Where's the learn button on a Genie garage door opener?

The Learn button on a Genie garage door opener is located on the motor unit mounted on ceiling of garage, typically near antenna wire, LED indicator, and logic board, but location varies by model. For Genie ChainLift, BeltLift, and SilentMax models, Learn button is usually on back or side panel of motor unit, square or round button, often labeled Learn, Program, or Set, near antenna wire that hangs down and LED light. On some Genie models, Learn button is under light cover, you may need to remove light lens to access button. On Genie models with Intellicode, Learn button is often purple, red, or black button. For Genie wall mount models, Learn button may be on wall control. To find Learn button, look on motor unit for button near where remote antenna hangs, check manual for your model number like ChainLift 1022, BeltLift 1042, SilentMax 1200 for exact location, as location varies. Once you locate Learn button, press and release it to enter programming mode, LED will light or blink for 30 seconds, then press remote button within 30 seconds to program. To erase all codes, hold Learn button for 10 seconds until LED turns off. So Learn button is on motor unit, usually back or side near antenna, may be under light cover.