Genie garage door openers do not have a dedicated button labeled reset, but the Learn or Program button acts as reset for erasing programming and power cycling resets logic board, similar to LiftMaster and Chamberlain. To reset programming and erase all remote controls, keypads, and Homelink codes on Genie opener, locate Learn or Program button on motor unit mounted on ceiling, usually square button near antenna wire and LED, press and hold Learn button for 10 seconds until LED turns off or blinks, indicating all codes erased, then reprogram remotes by pressing Learn button once and pressing remote button within 30 seconds. To reset travel limits and force settings to factory defaults, Genie models have Set and Limit buttons, you can reset by pressing and holding Set button per manual for your model like ChainLift 1022 or SilentMax 1200. To reset logic board after power surge, error, or erratic operation, unplug opener from power outlet for 30 seconds to 1 minute, then plug back in, power cycling resets board, disconnect battery backup if present. Some Genie wall controls have reset button. There is no single reset button that resets everything, but Learn button erases codes and power cycle resets board. Consult manual for your specific Genie model number for exact reset procedures.
1 votes
Marked as accepted