To program a Genie door opener, you use the Learn or Program button on motor unit to program remote controls, keypads, and Homelink. For remote control programming, locate Learn or Program button on motor unit mounted on ceiling, usually on back or side panel near antenna wire, press and release Learn button, LED will light or blink for 30 seconds indicating program mode, within 30 seconds press and hold button on remote you want to program until opener lights flash or you hear two clicks indicating success, then release and test remote. For wireless keypad programming, press Learn button, then within 30 seconds enter 4-digit PIN on keypad and press Program or Enter, opener lights flash indicating success. For Homelink in car, press Learn button on motor unit, then press Homelink button in car 2 to 3 times holding each time for 2 seconds until opener lights flash. For Aladdin Connect smartphone control, press Learn button then follow Aladdin app instructions. To erase all codes, hold Learn button for 10 seconds until LED turns off. Steps vary slightly by Genie model like ChainLift 1022, BeltLift 1042, SilentMax 1200, so consult manual for your specific model number. So programming involves Learn button on motor unit and remote button within 30 seconds.
1 votes
Marked as accepted