How to reset a Samsung Front Load Washer can be done via soft reset using control panel buttons or hard reset via power cycle, to clear error codes and reboot control board. Soft reset method, press Power button to turn off washer, wait 30 seconds, press Power again to turn on, then press and hold Start Pause for 5 seconds to cancel current cycle. To enter calibration mode after moving washer, with washer empty and turned on, press and hold Temp and Delay End buttons simultaneously for 3 seconds, then press Start Pause, washer will run calibration for drum. Hard reset method, turn off washer, unplug from wall outlet or turn off circuit breaker for 5 to 10 minutes to discharge capacitors, press and hold Power button for 5 seconds while unplugged, then plug back in, turn on, and run empty quick cycle to test. If error code persists like UB, ND, 4C, note code and troubleshoot accordingly. Reset can fix issues like door not unlocking, control panel frozen, or washer not starting after power outage. Always check manual for your specific model for button combinations.
1 votes
Marked as accepted