How do you reset the Samsung dryer to clear error codes and fix glitches, several methods. Simplest method is power reset, unplug dryer from wall outlet or turn off breaker for 5 to 10 minutes to let control board discharge, then plug back in and press Power to turn on, this clears temporary errors and resets electronics. Second method is control panel reset, with dryer on, press Power to turn off, then press and hold Start Pause button for 5 seconds, then Power on again. Third method is diagnostic reset, enter diagnostic mode by pressing and holding Mixed Load Bell and Wrinkle Prevent or Temp and Time buttons for 3 seconds until display shows t1, then press Power to exit which clears codes. For thermal fuse trip due to overheating, after cleaning vent, unplug dryer, remove back panel, locate thermal cutoff near heating element, press small reset button if present, then reassemble. Always check lint filter and vent for blockage before resetting, as overheating will trip again if vent clogged. If error like HE or tS persists after reset, part may need replacement. Consult manual for your model like DVE45R6100 for specific reset sequence.
1 votes
Marked as accepted