If your Lutron Diva LED+ dimmer switch exhibits a flashing or blinking status indicator or causes attached LED lights to flash, the issue is typically caused by incompatible non-dimmable LED bulbs, an unstable low-end dimming threshold, or loose wire terminal connections. First, verify that the installed bulbs are explicitly rated as dimmable LEDs. Second, use the dimmer's built-in low-end trim adjustment dial or slider calibration setting to raise the minimum dimming threshold until the flashing stops. Verification: Adjust the trim slider or dial until the LED bulbs illuminate steadily across their entire dimming range without any visible flickering or blinking.
1 votes
Marked as accepted