Rebooting or power-cycling a modern digital inverter generator or an electric-start backup generator to clear temporary electronic control board faults, sensor errors, or microprocessor freezes involves cutting all power sources. First, shut down the generator engine completely using the main power switch. Second, unplug all external electrical cords and loads from the receptacle panel. Third, locate the small 12-volt starting battery housed behind a service panel, and disconnect the negative battery terminal cable for a full sixty seconds to allow internal capacitors and memory chips to discharge completely. You can troubleshoot electronic resets safety by avoiding metal tool shorts. You can verify that your corrective action is successful when reconnecting the battery, turning the ignition switch to "On," and pulling the starter cord causes the generator to boot up with normal digital display operation and stable electrical output.
1 votes
Marked as accepted